System Builder
Pick the right EpiSensor and third-party devices for everything you need to monitor or control, and get a priced parts list and a system diagram you can share or turn into a quote.
Three sites, planned with System Builder. Each one lists the devices, what they cost and how they connect.
A food factory wants to see where its electricity and gas go, and to keep a record of two freezer rooms.
12
12 × Wireless 3-Phase Electricity Monitor
1
1 × Pulse Counter
2
2 × Probe Temperature Sensor
1
1 × Gateway
€8,791 hardware, before tax and delivery
A cold store runs four chill rooms and two freezers, and wants every room recorded with alarms, plus the energy the refrigeration plant uses.
6
6 × Probe Temperature Sensor
2
2 × Wireless 3-Phase Electricity Monitor
1
1 × Gateway
€3,913 hardware, before tax and delivery
A distribution centre with a 1,000 A incomer wants to shed a non-critical load when grid frequency falls, for a static frequency response programme.
1
1 × Demand Response Controller
1
1 × Gateway
€5,244 hardware, before tax and delivery
Each thing you can measure, by the signal it comes out on, and the device that reads it. Meters and controllers from other manufacturers are read through these interfaces or by Edge directly.
| Measurement | Measured directly | Pulse | M-Bus | Modbus RTU | 4-20 mA or 0-10 V |
|---|---|---|---|---|---|
| Electricity | CT clamps | Pulse counter | M-Bus interface | Modbus interface | |
| Gas and fuels | Pulse counter | M-Bus interface | Modbus interface | ||
| Water | Pulse counter | Modbus interface | |||
| Heat and cooling | Pulse counter | M-Bus interface | Modbus interface | ||
| Temperature | Probes | Modbus interface | Analogue sensor | ||
| Process and plant | Pulse counter | Modbus interface | Analogue sensor | ||
| Demand response | Controller with CTs |
Any meter with Modbus TCP, BACnet or OPC UA is read by Edge directly, and LoRaWAN meters report through the Gateway. The Device Directory lists them.
Each guide explains the measurements, the kit and the commissioning for one application.
A parts list with quantities and prices, a system diagram from the field points to the Gateway and Edge, and a link to the plan you can share, add to the cart or send to us for a quote.
Yes, one at each site. Every EpiSensor device reports over a Zigbee mesh to a ZGW-20 Gateway, which runs Edge on site. One Gateway carries up to 250 devices. If you already have one, say so and the plan leaves it out.
Answer "I’m not sure". Where one part fits whatever is there, the plan uses it, such as flexible coils for an unknown current. Otherwise the point is marked to be confirmed with our engineers, and the rest of the plan stays.
Edge comes pre-installed on the Gateway, with unlimited EpiSensor devices. A licence is only needed for each device from another manufacturer that Edge reads directly, at €6 per device per month billed annually, or once-off. Support and Core are optional.
Yes. Describe one site and say how many there are. Each site gets its own Gateway, and the quantities and prices cover all of them.
It chooses the demand response controller for the programme: static load shedding, the same with event evidence, or a changing set point for a battery or UPS. Every control route is confirmed with our engineers before ordering.