ELV-LW-OMO
Orientation/motion module of the ELV modular system reporting acceleration, tilt and button events. Reports occupancy.
Find meters, sensors and controllers by manufacturer, protocol and application, then see the exact route into EpiSensor Edge.
2959 searchable, source-backed device records
Orientation/motion module of the ELV modular system reporting acceleration, tilt and button events. Reports occupancy.
Zigbee in-wall smart switch with energy monitoring. Reports power and cumulative energy, and exposes a switched output.
Zigbee in-wall smart dimmer. Reports power and cumulative energy, and exposes a switched output and dimming.
Power meter. Reports voltage, current, cumulative energy, frequency and harmonic distortion. Connects over Modbus RTU (RS-485) and Modbus TCP.
Power meter. Reports voltage, current, cumulative energy, frequency and harmonic distortion. Connects over Modbus RTU (RS-485) and Modbus TCP.
Power meter. Reports voltage, current, cumulative energy, frequency, power factor and harmonic distortion. Connects over Modbus RTU (RS-485) and Modbus TCP.
Power meter. Reports voltage, current, cumulative energy, frequency and harmonic distortion. Connects over Modbus RTU (RS-485) and Modbus TCP.
The EGK-LW20W00 is a battery powered sensor intended for waste level measurement up to 1.5 meters. The device sends collected data over the LoRaWAN® network. The internal timestamp is synced with a downlink.
This compact energy meter can be used for monitoring the power consumption of the load, which can remotely be switched on/off. Equipped with a rechargeable battery for mains outage detection. The internal timestamp is synced with a downlink.
This device reads temperature, humidity, pressure, light intensity, air quality (expressed as IAQ or VOC value) and CO2. 3 traffic light LEDs for air quality display with adjustable brightness.
The MCF-LW12MET is an Enginko mcf88 LoRaWAN sensor with 1-phase energy measurement, which allows to monitor the power, voltage and current of electrical devices. It has an operating temperature of -10 °C to 70 °C and can be used in a variety of applications.
Smart thermostat. Exposes a switched output, an operating mode and a child lock with field calibration.
Zigbee Smart Thermostat Wireless. Exposes a switched output, an operating mode and a child lock with battery level and field calibration.
Zigbee smart thermostat. Reports humidity, and exposes a switched output, an operating mode and a child lock with field calibration.
Zigbee smart thermostat. Reports humidity, and exposes a switched output, an operating mode and a child lock with battery level and field calibration.
The 4/20mA LoRa sensor allows you to connect an analog 4/20mA probe (not included with the sensor). The signal generated by your 4/20mA probe will be read by the sensor and then sent via LoRa radio.
The level of CO2 is the main indicator of the air quality breathed by the building occupants. This data has a direct influence on the daily comfort of the occupants in enclosed spaces, and can trigger issues such as fatigue, drowsiness, and headaches.
The Enless LoRaWAN CO₂, temperature, and humidity sensor is specifically designed for indoor commercial environments.
No devices match your filters
Try a broader model fragment, manufacturer or application.
The database combines maintained Zigbee, LoRaWAN and Modbus sources for discovery. Exact manufacturer and model identities are joined; similar names are never assumed to be the same device.
A source record establishes a documented protocol route. A device page adds the model-specific interface, point map and commissioning steps, and where an Edge template exists it is offered there.
Third-party images are not republished without asset-rights review. Embedded upstream code is never executed. Modbus previews are read-oriented examples and must not be used as the basis for register writes.