IKEA INSPELNING

Compatibility

Compatible with EpiSensor Edge over Zigbee.

Pair it with the Zigbee radio on an EpiSensor Gateway. Edge reads it locally on the Gateway.

Edge reads 9 values from it, listed under Interface.

Connect it with

• 
  Gateway ZGW-20
  From €899 ex VAT Configure Gateway

Specifications

IKEA sells it for its DIRIGERA hub and app, and says it cannot be connected to the older TRÅDFRI gateway. Over Zigbee it reports active power, voltage, current and cumulative energy, can be switched on and off, and has settings for its behaviour after a power cut, a button lock and its LED. Firmware updates are delivered over Zigbee.^2, 4, 5

Power

Mains. Powered from the outlet it plugs into; the EU type takes 220 to 240 V AC, 50/60 Hz.¹

Maximum load (E2206)

3680 W, 16 A resistive; 300 W motor¹

Metering

Power, voltage, current and energy⁴

Radio

2405 to 2480 MHz, 10 dBm EIRP¹

Range

10 m in open air¹

Operating temperature

0 to 35 °C, indoor use only¹

Material

Polycarbonate plastic²

Standards (E2206)

EN 300 328, IEC 60884-2-5, EN IEC 61058-1, EN 18031-1 and -2³

Regional types

E2206 EU, E2220 US, E2223 UK, E2224 CH⁵

Zigbee model ID

INSPELNING Smart plug⁵

Where it is used

• Plug-in fridges, freezers and bottle coolers in staff rooms, shops and cafés, where each appliance's consumption and duty cycle is worth seeing on its own.

  Refrigeration energy monitoring

• Switching printers, screens and kitchen appliances off out of hours across a group of sites, with each plug's energy showing the saving.

  Multi-site energy monitoring

• A trial of plug-load metering before a site commits to meters on its distribution boards.

Interface

Readings and settings, with units and ranges where IKEA publishes them. R readable, R·W readable and writable, W writable only.^4, 6

The plug changes the divisor it applies to active power as the load changes. The divisor is reported whenever it changes, and a power value is only right when it is scaled by the divisor current at the time.⁵

On firmware older than 2.4.25 the LED setting works the other way round: setting it turns the LED off rather than on.⁶

IKEA's own app shows energy only through the DIRIGERA hub. On an EpiSensor Gateway the plug's metering clusters are read directly, with no IKEA hub involved.^1, 5

Setup

1. Factory reset it if it was used before

   Push the reset button with a pointed object for at least 5 seconds until the LED starts pulsating.¹

2. Open pairing in Edge

   In Edge, open pairing on the Gateway's Zigbee network, with the plug within its 10 m open-air range of the Gateway or a Zigbee router.

3. Start pairing

   Press the pairing button, in the small hole below the round on/off button, with a needle or paperclip for about two seconds.⁴

4. Check the identity

   Confirm that the plug reports its model as INSPELNING Smart plug. All four regional types report that same model ID, so the type (E2206, E2220, E2223 or E2224) is not visible over Zigbee.⁵

5. Check one reading

   Plug in a load of known rating, switch it on from Edge, and compare the power reading with the rating at a low and a high load, since the plug rescales power as the load changes.⁵