Meters, sensors and controllers, and how each connects to Edge.
136 device pages · 37 manufacturers with device pages
19 devices
Panel power meters for 1 A or 5 A current transformers, with Modbus RTU on RS-485 or Modbus TCP on Ethernet. Edge reads them through a Modbus interface, the Gateway’s serial port or the site network.
Self-powered single-phase LoRaWAN current transformers. Edge reads their decoded uplinks from your LoRaWAN network server.
Self-powered three-phase LoRaWAN current transformers with three split-core clamps. Edge reads their decoded uplinks from your LoRaWAN network server.
A battery-powered LoRaWAN current meter with three solid-core current transformers, reading AC current on each phase from 100 mA to 50 A with 1 mA resolution. Edge reads its decoded uplinks from your LoRaWAN network server.
A battery-free LoRaWAN current sensor with one or three clip-on CT clamps. Edge reads its decoded uplinks from your LoRaWAN network server.
A mains-powered Zigbee power meter with three split-core clamps, for one three-phase supply or three single-phase loads. Edge reads it through the Gateway’s Zigbee radio.
A two-channel Zigbee energy meter with 80 A current clamps that reports voltage, frequency, and each channel's power, current, power factor and energy, with calibration factors you can trim from Edge. Edge reads it through the Gateway’s Zigbee radio.
A single-phase Zigbee 3.0 energy clamp with one 80 A current transformer and room for a second, measuring voltage, current, power factor, active power and energy in both directions, to ±2 % above 100 W. Edge reads it through the Gateway’s Zigbee radio.
Clamp-on water flow meter and leak sensor. Reports temperature.
Clamp-on water flow meter and leak sensor. Reports temperature.
EM4301-CT is a 3phase Electricity Meter with measurement through current transformers.
Smart 1-phase energy power meter with CT sensor clamp. Reports voltage, current, power, cumulative energy and frequency.
Clamp meter. Reports voltage, current, power and cumulative energy.
3-phase clamp power meter.
3-phase clamp power meter with relay. Reports voltage, current, power, cumulative energy and exported energy, and exposes a switched output.
No devices match your filters
Try a broader model fragment, manufacturer or application.
Built from public Zigbee, LoRaWAN and Modbus device definitions and manufacturer documents. Exact manufacturer and model identities are joined; similar names are never assumed to be the same device.
A device that documents Zigbee 3.0, LoRaWAN or Modbus support connects to EpiSensor Edge through that protocol. A device page lists what the device reports, how to set it up and, where one exists, the Edge template for it.
Every page cites its sources. Zigbee device photographs come from the Zigbee2MQTT project and are credited under each photograph. We never run code from these sources, and register maps are for reading: never write to a meter from a map on this site.
Tell us the manufacturer and model, and we'll look at its documentation.
