PowerLogic PM5000
Connect a Schneider Electric PowerLogic PM5000 meter to EpiSensor Edge over Modbus RTU, Modbus TCP or, on supported models, BACnet/IP.
Find meters, sensors and controllers by manufacturer, protocol and application, then see the exact route into EpiSensor Edge.
2959 searchable, source-backed device records
Connect a Schneider Electric PowerLogic PM5000 meter to EpiSensor Edge over Modbus RTU, Modbus TCP or, on supported models, BACnet/IP.
Wiser 40/300-Series module switch 2AX. Exposes a switched output.
Wiser 40/300-Series module switch 10AX with ControlLink. Exposes a switched output.
LK FUGA wiser wireless socket outlet. Reports voltage, current, power and cumulative energy, and exposes a switched output and power-on behaviour.
Temperature & humidity sensor. Reports temperature and humidity with battery level.
Micro module switch. Exposes a switched output.
Wiser smart plug. Reports power and cumulative energy, and exposes a switched output and power-on behaviour.
Temperature/Humidity measurement with thermostat interface. Reports humidity, and exposes a heating setpoint with battery level.
Heating thermostat. Reports power and cumulative energy, and exposes a heating setpoint and an operating mode.
Wiser power micromodule. Reports power and cumulative energy, and exposes a switched output and power-on behaviour.
Power meter. Reports voltage, current, power, frequency, harmonic distortion and temperature.
No devices match your filters
Try a broader model fragment, manufacturer or application.
The database combines maintained Zigbee, LoRaWAN and Modbus sources for discovery. Exact manufacturer and model identities are joined; similar names are never assumed to be the same device.
A source record establishes a documented protocol route. A device page adds the model-specific interface, point map and commissioning steps, and where an Edge template exists it is offered there.
Third-party images are not republished without asset-rights review. Embedded upstream code is never executed. Modbus previews are read-oriented examples and must not be used as the basis for register writes.