Victron EV Charging Station (via GX)
Controllable load. Connects over Modbus TCP.
- Energy meters
Meters, sensors and controllers, and how each connects to Edge.
136 device pages · 37 manufacturers with device pages
469 devices
Controllable load. Connects over Modbus TCP.
Controllable load. Connects over Modbus RTU (RS-485) and Modbus TCP.
Energy meter. Reports power and cumulative energy, in charge-point, grid and solar roles. Connects over Modbus RTU (RS-485).
Energy meter. Reports power and cumulative energy, in grid, solar and battery storage roles. Connects over Modbus RTU (RS-485).
Energy meter. Reports power and cumulative energy, in charge-point, grid and solar roles. Connects over Modbus RTU (RS-485).
Energy meter. Reports power and cumulative energy, in charge-point, grid and solar roles. Connects over Modbus RTU (RS-485).
Energy meter. Reports power and cumulative energy, in charge-point, grid and solar roles. Connects over Modbus RTU (RS-485).
Energy meter. Reports power and cumulative energy, in charge-point, grid and solar roles. Connects over Modbus RTU (RS-485).
Controllable load. Connects over Modbus TCP.
Controllable load. Connects over Modbus TCP.
Controllable load. Connects over Modbus TCP.
Controllable load. Connects over Modbus TCP.
Power meter. Reports voltage, current, power, cumulative energy and frequency. Connects over Modbus RTU (RS-485) and Modbus TCP.
Power meter. Reports voltage, current, power, cumulative energy, frequency and demand. Connects over Modbus RTU (RS-485) and Modbus TCP.
Power meter. Reports current, power factor and demand. Connects over Modbus RTU (RS-485) and Modbus TCP.
The Decentlab DL-DLR2-004 is an Analog or Digital Sensor Device for LoRaWAN® that consists of an Analog 4 … 20 mA Sensor. Reports current.
The 4/20mA LoRa sensor allows you to connect an analog 4/20mA probe (not included with the sensor). The signal generated by your 4/20mA probe will be read by the sensor and then sent via LoRa radio.
The compact radio module for the T550 meters, transmits measurements of flow, backflow and energy in a heat or cold circuit with water using the ultrasonic principle.
Smart LoRaWAN® wall switch for thelocal and remote control of lights and electrical appliances. It adopts two standard sizes for most of international wall switcht ypes, which can replace the traditional wall switches directly.
Milesight WS558 is a LoRaWAN® Smart Light Controller that allows occupants to centrally control the lights on eight circuits. With remote and time-based ON/OFF, WS558 enables to improve the overall efficiency of electricity consumption in buildings.
YO Analog makes it possible to monitor devices and processes in automation. Reports voltage and current.
YO Power measures AC current flowing through devices connected to the mains. Reports current.
Zigbee smart energy meter. Reports voltage, current, power and cumulative energy.
Zigbee Mercury 3 Phase electricity meter. Reports voltage, current, power and temperature.
No devices match your filters
Try a broader model fragment, manufacturer or application.
Built from public Zigbee, LoRaWAN and Modbus device definitions and manufacturer documents. Exact manufacturer and model identities are joined; similar names are never assumed to be the same device.
A device that documents Zigbee 3.0, LoRaWAN or Modbus support connects to EpiSensor Edge through that protocol. A device page lists what the device reports, how to set it up and, where one exists, the Edge template for it.
Every page cites its sources. Zigbee device photographs come from the Zigbee2MQTT project and are credited under each photograph. We never run code from these sources, and register maps are for reading: never write to a meter from a map on this site.
Tell us the manufacturer and model, and we'll look at its documentation.