EPISENSOR | PULSE METER ACCEPTANCE RECORD
Revision: 22 September 2026
Guide: https://episensor.com/knowledge-base/pulse-meter-commissioning-and-reconciliation

One record for each pulse connection. Keep it with the site documents.
Keep credentials, passwords and access tokens out of this file.

1. SOURCE METER

Site and location: _______________________________________________________
Meter make, model and serial: ____________________________________________
Quantity measured (electricity, water, gas, heat): ________________________
Output type (dry contact / open collector / open drain / voltage): _________
Output terminals and polarity: ___________________________________________
Pulse weight, as read on the meter (with units): _________________________
Pulse width and minimum gap (from the manual): ____________________________
Photograph of nameplate and terminals taken? (yes / no): __________________

2. COUNTER

Counter model and serial: ________________________________________________
Input number and configuration: __________________________________________
Input limits (max rate, min on time, min off time): ________________________
Counter width in bits (counter and receiving system): _____________________

3. RATE CHECK

Maximum credible load or flow: ___________________________________________
Pulse rate at maximum (Hz): ______________________________________________
Inside the counter's limits? (yes / no): __________________________________
Time to rollover at maximum rate: ________________________________________

4. KNOWN-COUNT TEST

Pulses produced or observed: ____________________________________________
Raw count change: _______________________________________________________
Bounce or double counting seen? (yes / no): _______________________________

5. RECOVERY TESTS

Network interruption: count kept? (yes / no): _____________________________
Gateway restart: count kept? (yes / no): __________________________________
Counter power interruption (if safe and supported): ________________________
Duplicate counts after retransmission? (yes / no): _________________________

6. RECONCILIATION

                      Meter register      Raw count        Time
Start:                ______________      ____________     ________
End:                  ______________      ____________     ________
Change:               ______________      ____________
Converted change (raw count x pulse weight): _____________________________
Difference and explanation: ______________________________________________

7. ACCEPTANCE

Accepted by: ____________________________  Date: _______________________
Open items and owners: ___________________________________________________
_________________________________________________________________________